Guide to Assembling/Fixing a Stainless Steel Table with Under Shelf

Assembling a stainless steel table with an under shelf is a straightforward process, and with proper care, it can be completed efficiently. Follow these steps and refer to the YouTube video provided by the manager for a more visual guide.

Required Tools:

• A wrench (commonly provided in the packaging)
• Screwdriver (depending on the type of screws provided)
• Gloves (to protect your hands from sharp edges)

Step-by-Step Instructions:

1. Unpack the Parts:

Carefully remove all parts from the packaging. The package typically includes:

• Four legs (adjustable or fixed)
• Tabletop
• Under shelf
• Screws and washers

2. Identify the Parts:

Ensure you have all the parts mentioned above. Lay them out on a flat surface so you can easily access them.

3. Prepare the Tabletop:

Place the tabletop upside down on a flat, non-scratching surface (like cardboard or a soft cloth). The underside should be facing up, with the corners where the legs will be inserted clearly visible.

4. Attach the Legs:

Take one leg at a time and insert it into the pre-drilled holes on the underside of the tabletop. Secure the legs using the screws and washers provided. Tighten them slightly but not fully at this stage, as the table will need adjustments later.

5. Position the Under Shelf:

The under shelf should fit around the legs about 12–18 inches from the floor (or at the height you desire). Slide the under shelf down over the legs, aligning the holes or brackets on the legs with the attachment points on the shelf.

6. Secure the Under Shelf:

Once the under shelf is in place, insert the screws or bolts into the attachment points. Tighten them enough to hold the shelf securely but still allow for small adjustments.

7. Level the Table:

Turn the table upright carefully. Adjust the legs if they are designed to be adjustable, ensuring the table is level. This step is crucial for stability, so use a spirit level if available.

8. Final Tightening:

After ensuring the table is level and the under shelf is aligned, go back and fully tighten all screws and bolts. Be careful not to overtighten, as this could damage the table or strip the screws.

9. Check Stability:

Once fully assembled, give the table a gentle shake to ensure it is sturdy. If any wobbling occurs, adjust the screws or legs as necessary.

10. Cleaning and Safety:

Wipe down the surface of the table and under shelf with a soft cloth to remove any fingerprints, dust, or packaging residue before use.

Always follow safety precautions when assembling any equipment. For visual assistance, refer to the YouTube video link provided in your instructions for a more detailed walkthrough of this process.